Table of Contents
Advertisement
Available languages
Available languages
2. Installation
2.1 General installation guidelines
•
All installation work must be carried out by expert fitters in compliance with the general
directives regarding the technology for potable water installations.
•
The device must be set to ambient temperature before installation.
•
Only place device on a level ground.
•
Make sure that a connection to the drain is possible.
•
The device is fitted with a non-return check valve and therefore must not be fitted between
a water heater and the pressure relief safety valve.
•
Protect device against frost and extreme heat.
•
Putting the device into operation is part of the installations.
•
In soft water mode connected to galvanized pipework, phosphate dosing equipment
(Honeywell Habe Dos) should be fitted to protect the downstream pipework.
2.2 Preparation before installation
1.
Open pipe and thoroughly flush through.
2.
Install the device by its standard connectors (1").
☞
We recommend to use the connector set AS52-A (see 2.3).
Connection for the use in
the garden area
with p > 8 bar a
pressure reducing
valve is necessary
Drain outlet required
20
GB
Fine filter
required
230 V / 50 Hz
2.3 Installation with connector set AS 52-A (optional)
2.4 Assembling the drain hose
L
= 5 m
max
GB
Colored tag
on the right
Colored tag
on the right
21
Advertisement
Chapters
Table of Contents
