Honeywell HercuLine 10260A Installation, Operation And Maintenance Manual page 20

10260A Series Actuators Installation, Operations, and Maintenance Manual
Electrical
Feedback signals
Slidewire Emulation
Isolation
Load Requirement (4-20)
10 10260A Series Actuators – Installation, Operations, and Maintenance
Specification - Actuator with Output Board
0-20 mA
4-20 mA
1-5 Vdc with 250 ohm resistor ± 0.1 %
0-16 Vdc with 800 ohm resistor ± 0.1 %
Provides output voltage ratiometric to shaft position and potentiometric to supply
voltage (1-20 Vdc) without a slidewire. Emulates a 100 ohms to 1000 ohm slidewire.
10 mA output maximum.
Output is isolated from power and input signal by 240 Vac
Current Out — 0-1000 ohms
2/03