Husqvarna SVARTPILEN 401 Owner's Manual page 189

–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Change the rear wheel bearing.
–
Clean and grease shaft seal rings
A
surfaces
Long-life grease (
–
Clean the thread of the wheel spindle and axle nut.
–
Clean and grease the wheel spindle.
E01131-10
Long-life grease (
–
Clean the contact areas on the brake caliper bracket and link
fork.
–
Mount the damping rubber pieces and rear sprocket carrier
on the rear wheel.
–
Insert the narrow spacer into the side of the rear sprocket.
–
Insert the wide spacer into the side of the brake disc.
–
Position the rear wheel.
The brake linings are correctly positioned.
–
Push the rear wheel forward as far as possible and lay the
chain on the rear sprocket.
WHEELS, TIRES 14
1
and contact
of the spacers.
p. 277)
p. 277)
187