Makita BO4900V Instruction Manual page 5

For conventional type of abrasive paper without pre-
punched holes (optional accessory):
1
2
Turn the clamp lever counterclockwise. Insert the paper
end into the clamper, aligning the paper edges even and
parallel with the sides of the base. Then return the clamp
lever to the original position to secure the paper. Repeat
the same process for the other end of the tool, maintain-
ing the proper paper tension.
Place the punch plate (optional accessory) over the
paper so that the guide of the punch plate is flush with
the sides of the pad. Then press the punch plate to make
holes in the paper.
For hook-and-loop type of abrasive paper with pre-
punched holes (optional accessory):
Remove all dirt or foreign matter from the pad. Attach the
paper to the pad, aligning the holes in the paper with
those in the pad.
CAUTION:
• Never use pressure-sensitive abrasive paper.
For BO4901 only
NOTE:
• To use the hook-and-loop type of abrasive paper,
first replace the pad. Remove the pad for the
conventional type of abrasive paper from the tool
with a screwdriver.
Install the pad for the hook-and-loop type of
abrasive paper (optional accessory) on the tool.
Tighten the screws firmly to secure the pad.
001683
1. Punch plate
2. Conventional
type of abrasive
paper without
pre-punched
holes
001684
1. Hook-and-loop
1
type of abrasive
paper with pre-
2
punched holes
2. Pad for hook-
and-loop type of
abrasive paper
2
1
Installing paper dust bag
For BO4900, BO4900V only
Place the paper dust bag on the paper dust bag holder
with its front side upward. Insert the front fixing card-
board of the paper dust bag into the groove of the paper
dust bag holder.
1
Then press the upper part of the front fixing card-board in
arrow direction to hook it onto the claws.
1
Insert the notch of the paper dust bag into the guide of
the paper dust bag holder. Then install the paper dust
bag holder set on the tool.
2
5
004436
1. Pad
2. Screws
3
3. Screwdriver
001685
1. Groove
2. Front fixing
2
cardboard
3. Paper dust bag
3
001686
1. Claws
2. Upper part
2
001687
1. Guide
2. Notch
1