Connections - GE ATS125 Series Installation Manual

Connections

Table 2: ATS125x connections
Terminal block Wire
∼, ∼
CON1
+, −
CON2 +, −
+, −
S+, S− **
CON3 +, −
+, −
CON4 NO, COM, NC
NO, COM, NC
CON5 NO, COM, NC
NO, COM, NC
CON6 0V, D+, D−
T, C
CON7 1, 2, 3, 4
C
CON8 5, 6, 7, 8
C
CON9 12V, 0V, D+, D−
CON10 12V, 0V, D+, D−
* For 24 VDC models, always use two batteries in series.
** External siren output is a supervised output. Typical EOL resistor is 1 kΩ.
Mains power connection
Use the mains terminal to connect the mains-supply. A fixed cable, or a flexible mains
lead to an earthed mains outlet, can be used. In case fixed wiring is used, insert a
dedicated circuit breaker in the power distribution network.
WARNING: Disconnect the mains power before opening the cabinet!
Disconnect the AC mains plug from the AC mains wall socket.
—or—
Disconnect the mains with the dedicated circuit breaker.
2
Description
Mains power connection
System earth (see details on page 5).
2 x 12 V batteries, 7.2 Ah (24 V version) *
1 x 12 V battery, 7.2 Ah (12 V version)
Aux. power
Aux. power
External siren output
Lock 1 power
Lock 2 power
Door 1 relay
Door 2 relay
Door 3 relay
Door 4 relay
System databus and panel tamper wiring (see page 7 for details).
Tamper switch
Zone 1-4 inputs
Common
Zone 5-8 inputs
Common
Local databus to connect RASs and DGPs (see page 7 for details).
Local databus to connect RASs and DGPs (see page 7 for details).
ATS125x 4-Door DGP Installation Manual