6.2
Operation Check of the Remote Station
This section checks whether communications are performed between the master station and the remote station normally.
Configure the system as shown below.
Set the RUN/STOP/RESET switch of the CPU module on the master station to the RUN position.
For the communication setting, refer to Page 18 Communication Settings on GX Works3.
(1)
Ethernet
(1) Built-in Ethernet port
(2) Master station (station number 0)
(3) Remote station (station number 1)
(4) Local station (station number 2)
(5) General-purpose switching hub
(6) Code reader
Checking communications from the master station to the remote station
Turn M3024 ON forcibly.
Master station
1.
On GX Works3, select [Online] on the menu bar [Monitor] [Device/Buffer Memory Batch Monitor].
(2)
(3)
Y10 is turned ON.
Remote station
(4)
(5)
6 OPERATION CHECK
6.2 Operation Check of the Remote Station
(6)
TCP/IP
6
35