Makita DTW280 Instruction Manual page 8

Changing the impact
force
2
3
4
1. Changed in three steps 2. Hard 3. Medium 4. Soft
5. Button
Impact force grade
displayed on panel
Hard
Medium
Soft
You can change the impact in three steps: hard,
medium and soft mode.
This allows a tightening suitable to the work.
Every time the button
blows changes in three steps.
For approximately one minute after releasing the switch
trigger, the impact force can be changed.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Selecting correct socket
Always use the correct size socket for bolts and nuts. An
incorrect size socket will result in inaccurate and inconsis-
tent fastening torque and/or damage to the bolt or nut.
1
5
Maximum blows
Tightening when force
3,500
and speed are desired.
(min -1 )
2,600 Tightening when you need
(min -1 ) good controlled power.
Tightening when you need
1,800
fine adjustment with small
(min -1 )
diameter bolt.
is pressed, the number of
Application
Assembling the steel frame.
Assembling or disassembling
scaffolds or framework.
Assembling the furniture.
Installing or removing socket
For socket without O-ring and pin
► Fig.9: 1. Socket 2. Square drive
Align the hole in the side of the socket with the detent
pin on the square drive and push the socket onto the
square drive until it locks into place. Tap it lightly if
required.
To remove the socket, simply pull it off.
For socket with O-ring and pin
► Fig.10: 1. Socket 2. O-ring 3. Pin
Move the O-ring out of the groove in the socket and
remove the pin from the socket. Fit the socket onto the
square drive so that the hole in the socket is aligned
with the hole in the square drive. Insert the pin through
the hole in the socket and square drive. Then return the
O-ring to the original position in the socket groove to
retain the pin. To remove the socket, follow the installa-
tion procedures in reverse.
8 ENGLISH
Work