Miele WXI 860 WCS Operating And Installation Instructions page 68

Frequently Asked Questions
Fault message after the end of the program
Problem

Align the washing
machine

Check filter + jets
The messages will appear at the end of the program and when the washing
machine is switched on, and need to be confirmed with the OK sensor button.
68
Possible cause and solution
The SoftSteam extra option which runs at the end of
the program could not be carried out properly.
 Check whether the washing machine is aligned
correctly (see "Installation – Leveling the
machine").
 Check whether the maximum drain height of 3'
3" (1 m) has been exceeded.
If the fault message appears again, contact Miele
Customer Service. The washing machine can still be
used, but without the SoftSteam extra option.
The pumps are dirty.
 Clean the pumps as described in "Frequently
asked questions – Opening the door in the event
of a blocked drain and/or power failure".
 Start a wash program again after cleaning.
The jet in the top of the door ring is blocked with lint.
 Remove the lint with your finger. Do not use any
sharp or pointed tools to do this.
 Start a wash program again after cleaning.
If the fault message appears again, contact Miele
Service. The washing machine can still be used but
with reduced functionality.