Fault Message After A Program Has Been Interrupted - Miele WXI 860 WCS Operating And Installation Instructions

Frequently Asked Questions

Fault message after a program has been interrupted

Problem

Drainage See 

Water intake See


Waterproof system
Turn off   Ser-
vice

 Service Fault F
To switch off the fault indicator: Turn the program selector to the  position and
switch the washing machine off.
66
Possible cause and solution
The drain is blocked or restricted.
The drain hose has been fixed too high.
 Clean the drain filter and the drain pump.
 The maximum drain height is 39 ³⁄₈" (1 m).
Water intake is blocked or restricted.
 Check whether the faucet is turned on properly.
 Check whether the intake hose is kinked.
 Check whether there is sufficient water pressure.
The filter in the water intake is blocked.
 Clean the filter.
The drain pump is activated for 2 minutes. The
washing machine door is then released. Wait for the
drain pump to stop before switching the machine off.
The water protection system has reacted.
 Close the faucet.
 Contact Customer Service.
There is a fault.
 Disconnect the washing machine from the power
supply. Unplug the appliance or switch off the
breaker.
 Wait at least 2 minutes before reconnecting the
washing machine to the power supply.
 Switch the washing machine on again.
 Restart the program.
If the fault message appears again, contact Miele
Customer Service.