Troubleshooting - Sharp ESX156 Operation Manual

注 意
55
注意
16

Troubleshooting

CAUTION:
Some of the circumstances may not be a fault, please check before sending for repairs. If it is a fault,
please contact our service department, do not try to disassemble the washer or repair the washer
by yourself.
Display Problem Solution
• Water supply is too low. • Increase water supply.
• Water faucet is shut off. • Turn on the water faucet.
E1
• Filter net of water Inlet valve • Wash the filter net, remove blockage,
jammed. press the START/PAUSE button.
• Water level exceeded the highest • Program will automatically adjust the
E2 limit of the tub. water level and resume function.
• Abnormal water level.
• Lid open when running PRESET • Close the lid.
mode.
E3
• Lid is not close when Spin mode is
operating.
• Washing machine incline. • Adjust the adjustable leg.
• Clothes is collected on one side, • Open the lid and distribute the clothes
E4
causing unbalanced spin. evenly.
• Draining position is relatively high. • Lower down the drain hose, press
• Drainage hose is frozen or blocked. START/PAUSE button.
• Drainage hose is bent, squeezed, • Defreeze/unblock drainage hose, press
E5
tangled. START/PAUSE button.
• Smooth out drainage hose, press
START/PAUSE button.
• Lid is not close when safety lock is • Close the lid in 10s and program will
on. resume itself; if lid is still open after 10s,
E7
machine will start draining. To resume,
deselect SAFETY LOCK mode.
Common non-fault phenomenon
Phenomenon
Program stops during WASH/RINSE mode Water detector is working, it is normal.
Water inlet during WASH/RINSE mode Water detector detects low water level, inlet water automatically.
Program stop after WASH/RINSE mode Spin mode delay, it is normal.
When spinning, tub rotates discontinuously Program designated to be intermittently paused.
During SPIN mode, tub knocking and water start supply and Unbalance spinning causes program to autocorrect and resume, it is
enter RINSE mode normal.
Sounds of water flowing after SPIN mode end It is the sound of the fluid inside balance ring, it is normal.
Control panel heating up The memory part of PWB heating up, it is normal.
Operation button not working Pressing too soft.
SAFETY LOCK mode is on, deselect it.
Reason Summary of
Reason
①②
③④ ① Pipe leaking
⑤⑥
② PWB
breakdown
②④
③ Inlet valve
⑤⑥
breakdown
④ Circuit board
breakdown
②④
⑤⑦
⑤ Connection of
control panel
loosen off
⑥ Water level
④⑤
sensor breakdown
⑦
⑦ Safety lock
breakdown
②④
⑧ Drainage system
⑤⑥
⑧ ⑨ breakdown
⑩
⑨ Retractor
breakdown
⑩ Connection of
②④
retractor loosen off
⑤⑦
Possible reason and solution
13