Buffalo 320 Manual page 8

MAINTAINANCE
Lubrication
In order to keep your stilts operating freely, it is necessary to keep the
components reasonably clean and free of dents or burrs. Pay special
attention to the components which help operate the movement.
Lubricate these moving components lightly with a silicone spray or
white graphite powder. Do not use lubricating products which remain
wet and attract grit or any type of chemical cleaner. Make certain
soles are kept free of lubricants which could cause loss of traction.
WARNING:
Do not make modifications on parts. Always use genuine replacement
parts. Contact dealer for more information.
Replacement Nylon Sleeves
Remove wing bolts and remove the upper foot plate (together with the
extension tubes and floor plate). Pry the small sleeves from the
extension tube upper ends, and remove. The large sleeves can now
be removed. To reassemble, check extension tube holes for burrs, file
smooth. Slide new large sleeves down over the extension tubes until
the large sleeve tabs are aligned over the detents at the bottom of the
extension tubes. Insert new small sleeves over the top of the
extension tubes until it snaps past the upper locking tabs of the
extension tubes. Carefully insert the extension tube units all the way
into the stilt legs until the large sleeve tabs snap and lock into the stilt
leg slots. Check stilt operation by adjusting stilts up and down.
Replace wing bolts and tighten.