Maintenance - Makita TD00000111 Instruction Manual

Connecting USB devices
CAUTION:
Connect only devices that are
compatible with the USB power supply port. Not
doing so may cause a malfunction of the battery
holder.
NOTICE:
Before connecting a USB device to
the battery holder (with the battery), always back
up the data on the USB device. Not doing so may
cause a loss of your data.
NOTICE:
The battery holder may not supply
power to some USB devices.
NOTICE:
When not in use or after charging,
remove the USB cable and close the cover.
The battery holder (with the battery cartridge) can work
as an external power supply for USB devices.
Open the cover and connect a USB cable (not included)
to the USB port of the battery holder. Then connect the
other end of the cable to the device. To start charging,
press and hold the power button until the power level
indicator lights up. To stop charging, press and hold the
power button until the power level indicator turns off.
► Fig.5: 1. Cover 2. USB port
NOTE: The actual output current varies depending on
the USB device to be connected.
NOTE: Battery power is consumed while the power
button is turned on. Always turn off the switch when
not in use.
NOTE: When charging multiple USB devices in suc-
cession, wait about 10 seconds after charging of the
previous device has completed before beginning to
charge the next device.

MAINTENANCE

NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
NOTICE:
Do not wash the battery holder with
water.
— Wipe off dirt, dust, oil, grease, .etc on the housing
with clean dry cloth or one dipped in soapy water
and tightly wrung out.
— Keep the appliance in a place where it will not be
extremely hot, cold or humid.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
6 ENGLISH