Makita TD111D Instruction Manual page 6

CAUTION:
Always install the battery cartridge
fully until the red indicator cannot be seen. If not,
you or someone around you.
CAUTION:
Do not install the battery cartridge
forcibly. If the cartridge does not slide in easily, it is
not being inserted correctly.
Battery protection system
Overloaded:
an abnormally high current.
In this situation, turn the tool off and stop the application
the tool on to restart.
If the tool does not start, the battery is overheated. In
this situation, let the battery cool before turning the tool
on again.
Low battery voltage:
will not operate. If you turn the tool on, the motor runs
again but stops soon. In this situation, remove and
recharge the battery.
Indicating the remaining battery
capacity
Only for battery cartridges with "B" at the end of the
model number
Fig.2: 1. Indicator lamps 2. Check button
light up for few seconds.
Indicator lamps
Lighted Off
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
Switch action
Fig.3: 1. Switch trigger
CAUTION:
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.
speed is increased by increasing pressure on the switch
trigger. Release the switch trigger to stop.
NOTE:
ing the switch trigger for about 6 minutes.
Lighting up the front lamp
CAUTION:
source of light directly.
Fig.4: 1. Lamp
Fig.5: 1. Button
after releasing the switch trigger.
seconds.
similarly.
NOTE:
on, the lamp status is OFF.
NOTE:
-
this case, cool down the tool before operating again.
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
Remaining
capacity
Reversing switch action
Fig.6: 1. Reversing switch lever
75% to 100%
CAUTION:
50% to 75%
rotation before operation.
CAUTION:
25% to 50%
the tool comes to a complete stop. Changing the
direction of rotation before the tool stops may dam-
0% to 25%
age the tool.
CAUTION:
always set the reversing switch lever to the neu-
tral position.
of rotation. Depress the reversing switch lever from the
terclockwise rotation.
tion, the switch trigger cannot be pulled.
6 ENGLISH
Before installing the battery car-
Do not look in the light or see the
for one second within 10
Always check the direction of
Use the reversing switch only after
When not operating the tool,
-
-
-