Test Run - Grizzly T32251 Owner's Manual

4. Attach each eye shield bracket to (1) eye
shield support using (1)
flat washer, and (1)
Figure 18).
Eye Shield
Bracket
Figure 18. Eye shield bracket attached to eye
shield support.
5. Attach eye shield support connected to left
eye shield bracket to left wheel guard using
(1) ⁄ " flat washer and (1)
5
16
bolt (see Figure 19).
Note: Eye shield brackets are printed with "L"
for "left" and "R" for "right" to help distinguish
between them.
Left
Eye Shield
Bracket
Figure 19. Left eye shield support attached to
left wheel guard.
6. Repeat Step 5 with right eye shield support to
attach support to right wheel guard.
Model T32251/T32252 (Mfd. Since 08/20)
⁄ "-20 hex nut, (1)
1
4
⁄ "-20 x ⁄ " knob bolt (see
1 3
4 8
Eye Shield
Support
⁄ "-18 x ⁄ " knob
5 3
16 8
Eye Shield
Support
Left
Wheel Guard
⁄ "
1
4
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
The Test Run consists of verifying the following:
1) The motor powers up and runs correctly, and
2) the switch disabling key disables the switch
properly.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.

Test Run

-19-