Black & Decker KW82 Manual page 6

ENGLISH
f. Keep cutting tools sharp and clean.
Properly maintained cutting tools with sharp cutting edges
are less likely to bind and are easier to control.
g. Use the power tool, accessories and tool bits etc., in
accordance with these instructions and in the manner
intended for the particular type of power tool, taking
into account the working conditions and the work to
be performed.
Use of the power tool for operations different from those
intended could result in a hazardous situation.
5. Battery tool use and care
a. Ensure the switch is in the off position before
inserting battery pack.
Inserting the battery pack into power tools that have the
switch on invites accidents.
b. Recharge only with the charger specified by the
manufacturer.
A charger that is suitable for one type of battery pack may
create a risk of fire when used with another battery pack.
c. Use power tools only with specifically designated
battery packs.
Use of any other battery packs may create a risk of injury
and fire.
d. When battery pack is not in use, keep it away from
other metal objects like paper clips, coins, keys, nails,
screws, or other small metal objects that can make a
connection from one terminal to another.
Shorting the battery terminals together may cause burns
or a fire.
e. Under abusive conditions, liquid may be ejected from
the battery; avoid contact. If contact accidentally
occurs, flush with water. If liquid contacts eyes,
additionally seek medical help.
Liquid ejected from the battery may cause irritation or burns.
6. Service
a. Have your power tool serviced by a qualified repair
person using only identical replacement parts.
This will ensure that the safety of the power tool is
maintained.
Additional safety instructions for planers
Wait for the cutters to stop before setting the tool

down. An exposed cutter may engage the surface and
lead to possible loss of control and serious injury.
Electrical safety
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
corresponds to the voltage on the rating plate.
6
This appliance is not intended for use by young or infirm

persons without supervision. Children must be supervised
to ensure they do not play with the appliance.
If the supply cord is damaged, it must be replaced by the

manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. On/off switch
2. Lock-off button
3. Shavings discharge outlet
4. Planing depth adjustment knob
5. Planing depth graduation
Assembly
Warning! Before assembly, make sure that the tool is
switched off and unplugged.
Replacing the cutting blades (fig. A)
The cutting blades provided with this tool are reversible.
Replacement cutting blades can be obtained from your local
retailer.
Removing
Loosen the bolts (6) using the spanner supplied.

Slide the blade (7) out of the holder (8).

Reverse the blade so that the unused side comes in

position. If both sides are worn, the blade must be replaced.
Fitting
Slide the blade into the holder until it is centred in the holder.

Make sure that the holder remains centred in the barrel (9).

Tighten the bolts using the spanner supplied.

Always replace both cutters.

Adjusting the depth of cut (fig. B)
The depth of cut is indicated by the marking (10). The setting
range can be read from the graduation (5).
Turn the planing depth adjustment knob (4) to the required

depth of cut.
Turn the knob to the 'P' postion whenever the tool is not in

use.
Fitting and removing the parallel fence (fig. C)
The parallel fence (11) is used for optimum control on narrow
workpieces.
Hold the parallel fence (11) in front of the tool as shown.

Fit the parallel fence by inserting the locking knob (12) into

the hole (13).
Tighten the locking knob.

To remove the parallel fence proceed in reverse order.
