Speaker Setup; Digital Setup - AEG DVD 4516 TFT Operation Manual

Themen Changing the default settings

Speaker setup

Fig. 33
Fig. 34

Digital setup

Fig. 35
Fig. 36
Fig. 37
64
05-DVD 4516 AEG - GB Neu 64
Downmix
Change the characteristics of the speaker output:
LT/RT: Choose this setting if you want to play the DVD with the Pro
Logic Dolby stereo effect. This produces a almost real 2-channel
replay effect.
Stereo: Choose this setting if you want to play a DVD, that has
been produced in the 5.1-Audio format, as 2-channel stereo sound.
VSS: You may probably not have a 5.1-Audio system. In this case
you can use the „VSS"-setting to simulate a similar sound effect.
Bass-mode
Here you can defi ne the loudspeaker size.
LARGE SPEAKERS: frequency band 20 Hz - 20 kHz
SMALL SPEAKERS: frequency band 200 Hz - 20 kHz
MIXED SPEAKERS: Choose this setting if, for example, the centre
has a frequency band of 20 Hz - 20 kHz and the other loudspea-
kers a frequency band of 200 Hz - 20 kHz.
Night mode
Night mode activates a special Audio characteristic with which the
sound is felt less disturbing.
Dynamic Range
The term „Dynamic Range" describes the ratio of quietest and loudest
sound. If the dynamic range is very large, you will experience very
quiet and very loud sounds.
This may cause replay problems. Let us assume that you are watching
a DVD in a relatively loud environment. You can now increase the
volume to be able to hear also the very quiet passages, however with
the disadvantage that loud passages will be unacceptably loud. In
this case it would make sense to compress the dynamic range (i.e.
reduce) and increase the output volume at the same time.
FULL -2/8: The dynamic range is compressed slightly (2/8) to full
(FULL).
OFF: The dynamic range is not compressed at all (default).
Dual Mono
The Audio output is normally in stereo. Here you have the possibility to
choose Mono-output instead of Stereo-output.
Stereo: The Audio output is in Stereo (default).
Mono L: The Audio output is in Mono.
The sound from the „left-hand" stereo channel is output.
Mono R: The Audio output is in Mono.
The sound from the „right-hand" stereo channel is output.
Mix Mono: The Audio output is in Mono.
The sound of „both" stereo channels is output.
03.05.2006, 9:37:36 Uhr