Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Bang & Olufsen BeoLab 9
Summary of Contents for Bang & Olufsen BeoLab 9
- Page 1 BeoLab 9 Guide...
- Page 2 CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: To reduce the risk of electric shock, do not remove cover (or back). No User-serviceable parts inside. Refer servicing to qualified service personnel. WARNING: To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture.
- Page 3 This Guide describes how to set up a pair of loudspeakers and prepare them for use. The Guide provides useful information when you set up the loudspeakers for the first time, and later, if you have to move or rearrange your setup. Follow the instructions in this Guide carefully.
-
Page 4: Daily Use
When you have finished setting up the loudspeakers as described on the following pages, connect the entire system to the mains supply. The indicators light up in red, indicating that the loudspeakers are in standby, ready to be used. The loudspeakers are designed to be left in standby mode when not in use. - Page 5 We recommend that you follow this procedure when you set up the loudspeakers: – Disconnect your system from the mains supply. – Connect your loudspeakers and set the switch marked LINE–RIGHT–LEFT on each loudspeaker as explained in ‘Cable connections’ (pp. 6–7). –...
-
Page 6: Cable Connections
The loudspeakers can be used with Bang & Olufsen audio, video and link systems. They may also be connected to non-Bang & Olufsen systems. For specific information about the sockets on your system, refer to the Guide enclosed with the system. Cable connections FREE WALL... - Page 7 LEFT RIGHT Securing the cables: For safety reasons, the mains lead must be fastened to the loudspeaker. To do so, tug the mains lead behind the small bracket on the connection panel. Then run all cables behind the clamp, and tighten the two screws.
- Page 8 The loudspeakers may be placed almost anywhere in you room. However, the most natural sound is obtained if they are set up as explained on these pages. The Acoustic Lens Technology system ensures better balance in the high tone frequencies coming directly from each loudspeaker, and the sound reflected by the room.
- Page 9 BeoLab 2 to the sensitivity levels of different loudspeakers. If you set up a pair of BeoLab 9 loudspeakers in a system with BeoLab 2, we recommend that you set the BeoLab 2 SETUP switch to 1.
- Page 10 Waste Electrical and Electronic Equipment (WEEE) – Environmental protection The European Parliament and the Council of the European Union have issued the Waste Electrical and Electronic Equipment Directive. The purpose of the Directive is the prevention of waste of electrical and electronic equipment, and to promote the reuse and recycling and other forms of recovery of such waste.
- Page 11 For the US-market only! NOTE: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
- Page 12 www.bang-olufsen.com...