Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Bang & Olufsen BeoLab 4 PC
Summary of Contents for Bang & Olufsen BeoLab 4 PC
- Page 1 BeoLab 4 PC Guide...
- Page 2 CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: To reduce the risk of electric shock, do not remove cover (or back). No User-serviceable parts inside. Refer servicing to qualified service personnel. WARNING: To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture.
-
Page 3: Daily Use
Daily use When you have finished setting up the loudspeakers as described on the following pages, connect the entire system to the mains. Cleaning the loudspeaker You can clean the speaker panels with a vacuum cleaner set to the lowest suction level. Clean the other surfaces using a soft, lint-free cloth which you have dipped in lukewarm water and wrung firmly. -
Page 4: Set Up The Loudspeakers
We recommend that you follow this procedure: – Disconnect your system from the mains. – Connect the loudspeakers and set the LINE IN MODE switch on each loudspeaker as explained in ‘Cable connections’ (pp. 6–7). – Connect the entire system to the mains again. - Page 5 Loudspeaker front and side panels Each loudspeaker is equipped with one front panel and two side panels. These panels are fastened to the loudspeaker with three small pegs on the rear. The front panel is marked with a Bang & Olufsen name plate.
-
Page 6: Cable Connections
The loudspeakers are intended for use with a personal computer. They may also be used with non-Bang & Olufsen audio or video systems. About the LINE IN MODE switch … The switch has two settings: ON and AUTO. We recommend that you set the switch to the same position on each loudspeaker. - Page 7 LINE IN connections: Output from computer sound cards often carry both the left and right sound channels in one socket. Therefore, use the enclosed connector when connecting the loudspeakers to a personal computer (fig 1). Connect the plug marked L to the left loudspeaker, and the plug marked R to the right loudspeaker.
-
Page 8: Environmental Protection
Waste Electrical and Electronic Equipment (WEEE) – Environmental protection The European Parliament and the Council of the European Union have issued the Waste Electrical and Electronic Equipment Directive. The purpose of the Directive is the prevention of waste of electrical and electronic equipment, and to promote the reuse and recycling and other forms of recovery of... - Page 9 For the US-market only! NOTE: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
- Page 12 www.bang-olufsen.com 3509323 0610 Printed in Czech Republic by Z STUDIO...