Sony HT-MT500 Service Manual page 4

HT-MT500/MT501
MODEL IDENTIFICATION
Distinguish by Part No. and Destination code of the model number
label on the bottom side of the main unit.
MODEL NUMBER LABEL
Destination code
Model name
Destination
(color)
AEP
SA-MT500
(Charcoal Black)
UK
AEP
SA-MT501
(Crème White)
UK
DESTINATION ABBREVIATIONS
The following abbreviations for model destinations are used in this
service manual.
• Abbreviations
AEP : European (Except for UK, Ireland), Eastern Europe area,
CIS area (Moldova) and Middle East area (Jordan) mod-
els
UK : UK and Ireland models
4
– Bottom view –
Part No.
Destina-
Part No.
tion code
4-688-830-0[] CEL
CEK
4-689-744-0[]
4-688-832-0[] CEL
4-689-753-0[] CEK
RESETTING THE SYSTEM
It can return each settings to the initial state of factory shipment.
Note 1: To delete the Bluetooth pairing information, select the "All Set-
tings" in step 4 below.
1
Press HOME.
The home menu appears on the TV
screen.
2
Select [Setup] from the home
menu.
The setup display appears on the TV
screen.
3
Select [Resetting] - [Reset to
Factory Default Settings].
4
Select the menu item you want to
reset.
5
Select [Start].
To cancel resetting
Select [Cancel] in step 5.
If You Cannot Perform
Resetting Using the Home
Menu
Press and hold (power) and – on the
main unit for more than 5 seconds.
The settings return to their initial
status.
Note 2: By perform resetting, the link with the subwoofer may be lost. In
this case, refer to "WIRELESS CONNECTION (LINK) WORK
OF BAR SPEAKER AND SUBWOOFER" on page 7.
NOTE OF REPLACING THE MB-1610 BOARD OR
WLAN/BT COMBO CARD
When the MB-1610 board or WLAN/BT combo card is replaced,
be sure to perform with referring to the following item.
When replacing the MB-1610 board:
• NETWORK INFORMATION WRITING METHOD (refer to
page 5)
• NETWORK CONNECTION CHECKING METHOD (refer
to page 6)
• NFC CONNECTION CHECKING METHOD (refer to page
6)
• NOTICE OF MAC ADDRESS CHANGE TO CUSTOMERS
(refer to page 7)
• WIRELESS CONNECTION (LINK) WORK OF BAR
SPEAKER AND SUBWOOFER (refer to page 7)
When replacing the WLAN/BT combo card:
• NETWORK INFORMATION WRITING METHOD (refer to
page 5)
• NETWORK CONNECTION CHECKING METHOD (refer
to page 6)
• NFC CONNECTION CHECKING METHOD (refer to page
6)
• NOTICE OF MAC ADDRESS CHANGE TO CUSTOMERS
(refer to page 7)