After Use; Optional Accessories - Makita DLS714 Instruction Manual

5. Turn the 0° bevel angle adjusting bolt clockwise care-
fully until the side of the blade makes a perpendicular angle
with the top surface of the turn base. Use the triangular rule,
try-square, etc. as a guide. Then tighten the lever securely.
1
► 1. Triangular rule 2. Saw blade 3. Top surface of turn table
6.
Make sure that the pointer on the arm indicates 0° on the
bevel scale. If it does not indicate 0°, loosen the screw which
secures the pointer and adjust the pointer so that it indicates 0°.
1
2
► 1. Bevel scale 2. Pointer 3. Screw
45° bevel angle
► 1. Left 45° bevel angle adjusting bolt
Adjust the 45° bevel angle only after performing 0°
bevel angle adjustment.
1. Loosen the lever and tilt the blade to the left fully.
2. Make sure that the pointer on the arm indicates 45°
on the bevel scale. If the pointer does not indicate 45°,
turn the 45° bevel angle adjusting bolt (upper bolt) on the
right side of the arm until the pointer indicates 45°.

After use

After use, wipe off chips and dust adhering to the tool
with a cloth or the like. Keep the blade guard clean
according to the directions in the previously covered
section titled "Blade guard". Lubricate the sliding por-
tions with machine oil to prevent rust.
When storing the tool, pull the carriage toward you fully
so that the slide pole is thoroughly inserted into the turn
2
base.
To maintain product SAFETY and RELIABILITY,
3
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
OPTIONAL
ACCESSORIES
attachments are recommended for use with your
Makita tool specified in this manual. The use of
any other accessories or attachments may result in
3
serious personal injury.
or attachment for its stated purpose. Misuse of
an accessory or attachment may result in serious
personal injury.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
•
•
•
•
•
•
•
•
•
•
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
1
25 ENGLISH
WARNING:
These Makita accessories or
WARNING:
Only use the Makita accessory
Carbide-tipped saw blades
(Refer to our website or contact your local Makita
dealer for the correct saw blades to be used for
the material to be cut.)
Vise assembly (Horizontal vise)
Vertical vise
Holder assembly
Holder rod assembly
Set plate
Dust bag
Triangular rule
Hex wrench
Makita genuine battery and charger