Makita DLS714 Instruction Manual page 17

3. Return the blade guard and center cover to its
original position. Then tighten the hex socket bolt of the
center cover clockwise to secure the center cover.
4. Release the handle from the raised position by
pulling the stopper pin. Lower the handle to make sure
that the blade guard moves properly.
5. Make sure the shaft lock has released spindle
before making cut.
For tool with the inner flange for
15.88 mm hole-diameter saw blade
Country specific
Mount the inner flange with its recessed side facing
outward onto the mounting shaft and then place circu-
lar saw blade (with the ring attached if needed), outer
flange and hex bolt.
For tool without the ring
2
1
4
► 1. Outer flange 2. Saw blade 3. Inner flange 4. Hex
socket bolt (left-handed) 5. Spindle
For tool with the ring
2
1
4
5
► 1. Outer flange 2. Saw blade 3. Inner flange 4. Hex
socket bolt (left-handed) 5. Ring 6. Spindle
WARNING:
If the ring is needed to mount the
blade onto the spindle, always be sure that the
correct ring for the blade's arbor hole you intend
to use is installed between the inner and the outer
flanges. Use of the incorrect arbor hole ring may
result in the improper mounting of the blade causing
blade movement and severe vibration resulting in
possible loss of control during operation and in seri-
ous personal injury.
For tool with the inner flange for
other than 20 mm or 15.88 mm hole-
diameter saw blade
Country specific
The inner flange has a certain diameter of a blade
mounting part on one side of it and a different diameter
of blade mounting part on the other side. Choose a
correct side on which blade mounting part fits into the
saw blade hole perfectly.
3
► 1. Outer flange 2. Saw blade 3. Inner flange 4. Hex
socket bolt (left-handed) 5. Spindle 6. Blade mount-
ing part
CAUTION:
5
part "a" on the inner flange that is positioned
outside fits into the saw blade hole "a" perfectly.
Mounting the blade on the wrong side can result in
the dangerous vibration.
Connecting a vacuum cleaner
When you wish to perform clean cutting operation,
connect a Makita vacuum cleaner.
3
6
17 ENGLISH
2
1
4
Make sure that the blade mounting
3
5
6