Bosch Pack201HS Instruction Manual page 78

Pack201 | Operator Interface | Section 4
PARAMETER
Home Rate (ppm)
Hot Shoe Enable
Hot Shoe Off Delay
Hot Shoe On Delay
Infeed Pitch (pitches)
Infeed Reject Enable
Jam Eye Delay (sec)
Jog Rate (ppm)
Lineshaft X Enable
Lineshaft X Linear Offset
Lineshaft X Rotary Offset
Lineshaft X Rotary Ratio
(Cycles/Product)
Long Product # To Reject
Long Product Reject (on/off)
Long Product Reject Shifts
LPF/Sweep Chain Pitches
LPF/Sweep Offset
LPF/Sweep Ratio
Master Phase
Maximum Missed Registration
Melted Film # To Reject (prod)
Melted Film Reject Enable
© Bosch Packaging Technology, Inc.
All rights reserved 2012
DEFINITION
This is the desired speed in packages per minute that the wrapper will
run during the homing sequence�
In the ON position the hot shoe option is active� In the OFF position the
option is disabled�
This is the distance in film travel that the hot shoe will remain operating
after a No Product No Paper condition is detected�
This is the distance in film travel that the hot shoe will remain open
after a No Product No Paper condition is cleared�
This is the number of chain pitches between every two pushers on an
infeed chain�
In the ON position the infeed reject eye is active� In the OFF position the
reject eye is disabled�
This is how long the machine waits when the jam eye is blocked before
the machine stops�
This is the desired wrapper speed in packages per minute while the
machine is in jog mode�
In the ON position the lineshaft axis is active� In the OFF position the
axis is disabled�
This is a correction that may be added to change the position of the
device being driven by the lineshaft�
This is a correction that may be added to change the position of the
device being driven by the lineshaft�
This is the number of cycles the lineshaft driven device must turn for
each product�
This is the desired number of packages to reject when a long product is
detected�
In the ON position the long product reject eye is active� In the OFF posi-
tion the reject eye is disabled�
This is the number of cycles from the long product reject eye to the
reject device�
This is the number of inches between chain pushers times 2�
This is a value that can be added to change the placement of the prod-
uct in the infeed conveyor flight.
This is the ratio of LPF or Sweep products to wrapper infeed chain
flights.
This is a signal from a device that allows the wrapper to be timed to the
device�
This is the maximum number of consecutive registration marks not de-
tected before the wrapper will stop�
This is the desired number of packages to reject when a melted package
is detected�
In the ON position the melted film reject is active. In the OFF position
the reject is disabled�
EN | 47