4.7 Parameter Definitions - Bosch Pack201HS Instruction Manual

Pack201 | Operator Interface | Section 4

4.7 Parameter Definitions

PARAMETER
Accel Rate (sec)
Accum Hi Speed Ratio (%)
Accum High Speed Delay (mm)
Accum Low Speed Delay (mm)
Accum Low Speed Ratio (%)
Angle Off Discharge Reject (deg)
Angle Off Generic 1 (or 2) Reject (deg)
Angle Off Infeed Reject (deg)
Angle Off Long Product Reject (deg)
Angle Off NGNS (deg)
Angle Off NPNP (deg)
Angle Off Pulse X (deg)
Angle Off Reject Verify (deg)
Angle Off Short Product Reject (deg)
Angle Off Tucker (deg)
Angle Off Uncut Reject (deg)
Angle Off Window Stop
Angle On Discharge Reject (deg)
Angle On Generic 1 (or 2) Reject (deg)
Angle On Infeed Reject (deg)
Angle On Long Product Reject (deg)
Angle On NGNS (deg)
Angle On NPNP (deg)
© Bosch Packaging Technology, Inc.
All rights reserved 2012
DEFINITION
This is the time required for the wrapper to go from a stopped position
to 600 packages per minute�
This is the ratio of the feeder accumulator belt high speed to the wrap-
per speed�
This is a delay added to prevent the feeder accumulator belt from going
to high speed as soon as the accumulator eye is blocked�
This is a delay added to prevent the feeder accumulator belt from going
to low speed as soon as the accumulator eye is unblocked�
This is the ratio of the feeder accumulator belt low speed to the wrap-
per speed�
This is the position in a cycle where the discharge reject air blast stops�
This is the position in a cycle where the generic reject eye stops check-
ing for the reject condition�
This is the position in a cycle where the infeed reject air blast stops�
This is the position in a cycle where the long product reject eye stops
checking for a long product�
This is the position in a cycle where the missing product eye stops
checking for a product�
This is the position in a cycle where the missing product eye stops
checking for a product�
This is the position in a cycle where pulse X ends�
This is the position in a cycle where the verification eye stops checking
for a product�
This is the position in a cycle where the short product reject eye stops
checking for a short product�
This is the position in a cycle where the air tucker stops making a tuck
in the package�
This is the position in a cycle where the uncut eye stops checking for an
uncut package�
This is the position in a cycle where the stop window ends�
This is the position in a cycle where the discharge reject air blast starts�
This is the position in a cycle where the generic reject eye starts check-
ing for the reject condition�
This is the position in a cycle where the infeed reject air blast starts�
This is the position in a cycle where the long product reject eye starts
checking for a long product�
This is the position in a cycle where the No Gap eye starts to check for a
product�
This is the position in a cycle where the missing product eye starts to
check for a product�
EN | 44