I/O Port - Honeywell HD-SDC-3300P User Manual

Installation

I/O Port

10
• Unplug the auto lens cable socket from the auto lens connector. If you are
using the manual aperture lens, please skip the step.
• If there is no lens, please put the CCD protection cap back to protect the
CCD.
Figure 3-3 Remove Lens
Please check input voltage and device power button match or not.
Install Cable
Please follow the steps listed below to install the cable. See
Use the small slotted screwdriver to press the corresponding button of cable
groove. Insert the cable into the groove and then release the screwdriver.
Remove Cable
Please follow the steps listed below to remove the cable.
Use the small slotted screwdriver to press the corresponding button of cable
groove. Remove the cable out of the groove and then release the screwdriver.
Figure 3-4.