Configure A Router With Advanced Mac Settings To Work With Your Extender - NETGEAR AX1750 EAX18 User Manual

GHz band is used to connect the extender to the WiFi router. Use this mode if
your WiFi router supports the 5 GHz band, but the devices that you want to use
for gaming and streaming support the 2.4 GHz band.
8. Click the SAVE button.
Your changes are saved.
Configure a router with advanced MAC
settings to work with your extender
If you enabled a WiFi MAC filter, WiFi access control, or access control list (ACL) on your
router, when a WiFi device connects through the extender to your router, the MAC
address of the WiFi device shown on the router is translated to another MAC address.
If your router's MAC filter, WiFi access control, or ACL is enabled, the WiFi device
connects to the extender but cannot get an IP address from the extender and cannot
access the Internet.
To allow the WiFi device to receive an IP address from the extender and access the
Internet, you must provide translated MAC address to the router.
To add a translated MAC address to your router and reserve an IP address for your
extender
1. Log in to your router and disable the MAC filter, WiFi access control, or ACL.
For more information about how to disable your router's MAC filter, WiFi access
control, or ACL, see your router's documentation.
2. Power on the extender and connect all of your WiFi devices to the extender.
3. Make sure that the Router Link LED remains lit.
Extender Network Settings
AX1750 4-Stream WiFi 6 Mesh Extender
41 User Manual