Operation - Breville the AirDynamic 3D Connect Instruction Book

3. To place the rear grille onto the motor head,
align the motor head with the locating tab
on the rear grille. Ensure the upward arrow
mark on the motor head aligns with the
upward arrow mark on the rear grille.
4. Refit the rear grille locking nut and secure
the rear grille by turning the locking nut
clockwise (Fig 5). Make sure the rear grille
has not slipped off the locating pins before
tightening. This should be done by hand.
Do not use force to secure.
Fig 5
5. Align the grooves found at the back centre
of the blade with the motor shaft pin and
push all the way down.
n
NOTE
The back of the blade can be distinguished
from the front by a distinctive O symbol found
on the blade fin.
6. Refit and secure the blade cap onto the
motor shaft by turning counter-clockwise
(Fig 6). This should be done by hand. Do
not use force.
10
Fig 6
7. Place the front grille onto the rear grille
so that the left line mark on the top of the
rear grille is aligned with the line mark
on the front grille. Turn clockwise to lock
into place.
HINT:
Once the front and rear grilles are assembled
correctly, the Breville logo will be straight.
8. Securely tighten the assembled grilles
using the Phillips screw and the Allen key
provided (Fig 7).
Fig 7
TIGHTEN
9. Connect the power adaptor into the power
inlet found on the anti-topple base. The air
circulator is now ready for use.
o

Operation

OPERATING YOUR BREVILLE
AIR CIRCULATOR
1. Place the air circulator on a flat surface. Use
the Where to Position Your Air Circulator
section in this book for positioning
depending on requirements.
2. Insert the power plug into a 230V or 240V
power outlet and switch the power outlet on.
The LED display will illuminate to display
the current room temperature. The air
circulator is now in standby mode.
3. Touch the button to turn the air
circulator on. The air circulator will
automatically start in NORMAL mode at
fan speed 1.
n
NOTE:
To return to standby mode at any time during
operation, touch the button.
w
CAUTION:
Never insert fingers, pencils or any other
objects through the guards whenever the
power plug is connected, in particular while the
air circulator is switched on.
ROOM AMBIENT TEMPERATURE
Your Breville Air Circulator is fitted with a
temperature sensor that detects the room
temperature which will display through the
LED display. The figure displayed is only an
indication of the room temperature and will
vary depending on the location of the air
circulator in the room.
The LED display shows ambient temperature
only, or cycles to show the ambient
temperature and the setting depending on the
selected mode.
11