Makita DBS180RTJ Instruction Manual page 7

Cordless belt sander
Hide thumbs Also See for DBS180RTJ:
Table of Contents

Advertisement

Adjusting arm inclination
The arm can be pivoted and fixed at any desired angle
within the range "A" (-5° to 90°) in the figure. Adjust the
angle to make a comfortable working position.
Loosen the lock lever by raising it. Pivot the arm to the
desired position, and secure the lock lever to fix the arm
firmly.
1
► 1 . Lock lever 2. Arm
Replacing arm
6 mm (1/4") and 13 mm (1/2") width belts can be
installed with the optional arms that are designed for
the corresponding belt widths. Loosen the screw that
secures the arm and replace the standard-equipped
arm with the optional arm, then tighten the screw firmly.
1
► 1 . Screw 2. Arm
2
"A"
2
Switch action
WARNING:
For your safety, this tool is
equipped with the lock-off switch which prevents
the tool from unintended starting. NEVER use
the tool if it runs when you simply pull the switch
trigger without releasing the lock-off switch.
Return the tool to our authorized service center
for proper repairs BEFORE further usage.
CAUTION:
Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released. Operating a tool
with a switch that does not actuate properly can lead
to loss of control and serious personal injury.
NOTICE:
Do not pull the switch trigger hard with-
out releasing the lock-off switch. This can cause
switch breakage.
NOTICE:
The lock-off switch cannot be released
while the arm is being pivoted beyond 90°.
To prevent the switch trigger from being accidentally
pulled, a lock-off switch is provided. Depress the switch
lever (
) from the A side to unlock the switch trigger,
and (
) from the B side to lock in.
► 1 . Lock-off switch
To start the tool, pull the switch trigger. Release the
switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock button. To stop the tool from the
locked switch position, pull the switch trigger fully, and
then release it.
► 1 . Lock-on button 2. Switch trigger
7 ENGLISH
1
A
1
B
1
2

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dbs180z

Table of Contents