Operating Modes; 2-Wire Operating Mode (Default) - ABB ACS880+N5350 User Manual

The ACS880+N5350 can be placed in any one of 5 different operating modes. These modes are used to quickly set up the
drive to operate from the drive terminal strip or from a network communications card. Many inputs are still programmable.
NOTE: Stop drive and place drive in "Local" before changing mode. Cycle power or reboot drive after changing mode.
CAUTION: Drive may start unexpectedly on changing mode.

9.1 2-Wire Operating Mode (Default)

Figure 9-1 ACS880+N5350 2-Wire Operating Mode Connection Diagram (76.03 = 1)
3AXD50000011888
XP0W External power input
1 +24VI
24 VDC , 2 A
2 GND
XAI Reference voltage and analog inputs
1 +VREF 10 VDC , R
2 -VREF -10 VDC , R
3 AGND Ground
4
AI1+ Speed reference
5 0(2)...10 V, R
AI1-
6
AI2+ By default not in use
7 0(4)...20 mA, R
AI2-
XAO
Analog outputs
1
A01 Motor speed rpm
2 AGND 0...20 mA, R
3 A02 Motor torque %
4 AGND 0...20 mA, R
XD2D Drive-to-drive link
1 B
2 A Drive-to-drive link
3 BGND
XR01, XR02, XR03 Relay outputs
1 NC
2 COM
3 NO
1 NC
2 COM
3 NO
1 NC
2 COM
3 NO
XD24 Digital interlock
o
t
1 DIIL Digital Interlock, Thermostat, Ramp Stop
2 +24VD +24 VDC 200 mA
3 DICOM Digital input ground
4 +24VD +24 VDC 200 mA
5
DIOGND Digital input/output ground
XDIO
Digital input/outputs
1
DI01 Trickle current enable
2
DI02 De-Ice mode enable
XDI
Digital inputs
1
DI1 Stop (0) / Start (1)
2 DI2 By default, not in use
3 DI3 Acc/Dec �me set 1 (0) / set 2 (1)
4 DI4 Constant speed 2 (1 = On)
5 DI5 Reset Fault
6 DI6 External Event, Vibra�on Switch
Safe torque off circuits must be closed for the drive
XSTO
to start. See Hardware manual of drive.
X12
Safety op�ons connec�on
X13
Control panel connec�on
X205 Memory unit connec�on
Chapter 9

Operating Modes

1...10 kohm
L
1...10 kohm
L
> 200 kohm
in
> 200 kohm
in
> 500 ohm
L
> 500 ohm
L
Ready
250 VAC / 30 VDC
2 A
Running
250 VAC / 30 VDC
2 A
Faulted (-1)
250 VAC / 30 VDC
2 A
Operating Modes 9-1