Replacement Of Fader - Sony DNE-1000 Maintenance Manual

3-3. BKNE-1011

3-3-2. Replacement of Fader

3-3-2. Replacement of Fader
1. Fader Assembly
(1) Remove the fader grip, the four knobs and the five
slide knobs.
(Refer to the steps 1 and 2 of the section 2-3-1.)
(2) Remove the upper panel assembly.
(Refer to the step 3 of the section 2-3-1.)
(3) Disconnect the two connectors (CN7 and CN8) on the
CPU-207 board. (Refer to the step 4 of the section 2-
3-1.)
(4) Remove the four screws and the fader assembly.
(Refer to the step 7 of the section 2-3-1.)
(5) Install a new fader assembly in the reverse order of the
steps (1) through (4).
3-4(E)
2. Slide Knob
(1) Remove the fader grip, the four knobs and the five
slide knobs. (Refer to the steps 1 and 2 of the section
2-3-1.)
(2) Remove the upper panel assembly.
(Refer to the step 3 of the section 2-3-1.)
(3) Disconnect the two connectors (CN7 and CN8) on the
CPU-207 board. (Refer to the step 4 of the section 2-
3-1.)
(4) Remove the four screws and the VR fitting bracket.
(Refer to the step 6 of the section 2-3-1.)
(5) Remove the two screws of the fader to replace.
(6) Remove the each heat-shrinkable tube of harnesses to
replace the fader and desolder the harnesses.
Harness (soldering)
Heat-shrinkable tube
VR fitting bracket
(7) Install a new fader in the reverse order of the steps (1)
through (6).
n
When soldering the harness to the fader, put the heat-
shrinkable tube (ø3) through the harness.
Fader
B 3x4
DNE-1000