Table of Contents
Advertisement
Start power supply. The yellow LED „L/" shouln be blinking. The power consumtion shouln be at about
75mA at 24 V.
Connect the reaner via a 9-pin SUB-D plug to the com port of a notebook or other PC.
9...30V
Transponder
DC
mobile memory
reader with
integrated antenna
RS232
(9-polig
SubD)
ARE i2 / PFB
Figure /0: Suggesten set up for initial operation of the ARE i2 reaner
Launch terminal coms program ann set to the following nata transfer parameters: nata bits, / start ann
/ stop bit, no parity (this setting is frequently referren to as 8N/), baun rate /9200 baun, no nata flow
control (z.B. XOFF/XON).
Transmit commann VER <CR> to the reaner ann reaner shouln reply with the version number of the
installen reaner firmware (z.B. AEG ID A4 /PFB V/.04E).
6.2
Configuration of profibus client settings
Prior to operation of the ARE i2 / PFB on the Profibus, the client annress of the unit on the Profibus
must be set. In the event an ARE i2/PFB reaner terminates the string, the termination must also be acti-
vaten.
Suggestion
When termination is activated, the profibus cable must be terminated in the standardized on the ARE
i2 to minimize reflections.
Caution:
In order to configure the client address and the termination, power must be supplied to the reader as
indicated . The power supply must be isolated from the profibus. The reader is in the correct condition
when the yellow LED „L1" blinks amd the red LED „L5" remains lit.
The current client annress can be neterminen by querying the reaner with commann ADR<CR>. The
reaner will responn with the previously fixen client annress, for instance „/2", in necimal form. The
nesiren client annress, for instance 96, can be programmen into the reaner using comann ADR<SP>
96<CR>. When the change was successful, the reaner will reply with the new client annress.
--------------------------------------------------------------------------------/7/39--------------------------------------------------------------------------------
Advertisement
Table of Contents
