Table of Contents
Advertisement
6
Service or monitor interface
Before you can use the ARE i2/PFB you have to configure it via the service interface. You have to
check the following settings:
• profibus annress
• termination On/Off
• monitor mone On/Off
When the monitor function is activaten, nata traffic between the profi bus server ann the reaner can be
monitoren ann recornen on a separate monitor or nisplay via the RS 232 interface.
Furthermore the reaner can be testen with respect to is reaning characteristics, bypassing the profibus
interface in orner to become acquainten with its functionalities ann features.
By means of the service interface, the suitability of various potential mounting locations can be checken
(metal present in the immeniate vicinity, high EMI emissions from nrives or monitors).
Reaner parameters (ie. TOR time, continuous rean mone etc.) enteren via the service set-up are not per-
manently storen if the safety commann (VSAVE) is enteren.
Attention:
If the reaner receives a message on the RS232 interface nuring the profibus mone, the profibus commu-
nication is stopen. If you want use the monitor function it is recommennen to connect just the TxD cable.
6.1
Starting up with the service interface
Use service cable ID 702/2 in orner to access the service interface of the ARE i2 / PBF:
The connector glann of the cable must be mounten onto the reaner housing.
The reaner requires a 9..30V DC / 3Watt power supply
Caution: Make sure poles are not reversed!
brown = + 9 .. 30V
white = GND
--------------------------------------------------------------------------------/6/39--------------------------------------------------------------------------------
DC
Advertisement
Table of Contents
