Sony SAL135F28 Service Manual page 34

Ver 1.2 2007.01
HELP30
Adhesive bond (B-10): J-6082-612-A
1. Apply the adhesive bond (B-10) in the width of 10 mm to the two instruction portions of the front frame as shown in the figure.
2. Attach the G2 stopper.
Note:
Apply the adhesive bond so that it can not be visible from exterior.
HELP31
Be sure to replace the lens (G2+G3) and station adjustment washer as a set.
Different combination may cause the flange back adjustment not available.
When replacing the lens (G2+G3) with the service parts, check enclosed insert for its compensation value. Then select the suitable station
adjustment washer according to the Table-1 below.
Note:
Never separate the lens (G2+G3) and insert. The compensation value is not written on the parts.
Compensation value of lens
Compensation value of lens (G2+G3)
+0.05 to +0.03
+0.02 to -0.02
–0.03 to –0.05
Curver field adjustment washer
Part No.
2-688-957-01 Curver field adjustment washer A
2-688-958-01 Curver field adjustment washer B
2-688-959-01 Curver field adjustment washer C
SAL135F28 (STF 2.8(T4.5)/135) (135mm F2.8 [T4.5] STF)
G2 Stopper
Apply the Adhesive Bond
(B-10) (Two areas)
Front Frame
Combination of station adjustment washer
Curver field adjustment washer C
Curver field adjustment washer A x 2
Curver field adjustment washer B x 2 and Curver field adjustment washer C
Description Thickness (mm)
G2 Stopper
0.192
0.105
0.255
HELP