System Connections - Kenwood DM-VH7 Instruction Manual

12

System connections

Make connection as shown below. When con-
necting the related system components, refer
also to the instruction manuals of the related
components.
Caution: Do not plug in the power lead until all
connections are completed.
When installing this unit, reserve a clearance of at
least 10cm from the rear wall.
RD-VH7 (optional)
TO
AC OUTLET
¶ To enable system operations including CD recording, it
is recommened to connect the CD receiver (RD-VH7)
to "DIGITAL IN OPTICAL 1".
¶ Commercial digital equipment (BS tuner, DAT, etc.)
can be connected to "OPTICAL 2".
1. Connect all cords firmly. If connections are loose, there could be loss of sound or noise produced.
2. When plugging and unplugging connection cords, be sure to first remove the power cord from the AC outlet.
Notes Notes
Plugging/unplugging connection cords without removal of the power cord can cause malfunctions or damage
to the unit.
DIGITAL
OUT
OPT ICAL
System control cord
WALL
¢∞
§º
Malfunction of microprocessor
If operation is not possible or erroneous display
appears even though all connections have been
made properly, reset the microprocessor refer-
ring to "In case of difficulty".
Optical fiber cable
SYSTEM
CONTROL
Audio cord
SYSTEM REC PLAY
CONTROL IN OUT
L
R
DIGITAL IN jack
(OPTICAL)
Remove the protec-
tive cap before using
the DIGITAL IN jack.
Remove cap.
¶ Be careful not to lose the protective caps.
L
MD
R
REC PLAY IN
OUT
Audio cord
1 2
DIGITAL IN
OPTICAL
1
DIGITAL IN
OPTICAL
DM-VH7 (EN)
u