Lenovo T1 User Manual page 15

Instructions
Partial cleaning
When the machine is on standby or pause, press the partial
cleaning button to start partial cleaning. This mode can clean
a 1.6m x 1.6m square area taking the machine as the center.
After the cleaning, the machine will automatically return to the
starting position and stop working.
Note: Starting partial cleaning when in pause will end the last
cleaning and start a new cleaning task.
Adding water in the water tank or cleaning mop
during cleaning
If the machine needs to add water or clean the mop during
cleaning, please press the power button to pause before removing
the mopping module. After adding water or cleaning mop, re-install
the mopping module and press
Fault condition
When abnormality occurs in the operation of the machine, the
power button indicator flashes orange and voice prompt sounds.
For solutions, please refer to page 20, "Troubleshooting".
Note:
After 10 minutes under the fault condition without operation,
the machine will automatically sleep.
to continue working.
Sleep mode
If there is no operation for more than 20 minutes, the machine
will enter sleep mode automatically. In the sleep mode, after
the breathing light turns out, the machine can be activated by
pressing any button.
Note:
The machine will not enter sleep mode when charging on
the charging base.
When it turns low battery during sleep mode, the machine
will automatically shut down
Reset WiFi
When the configuration of router is changed, password
forgotten or the mobile phone fails to connect to the
machine by other causes, press and hold the
and button until the voice prompt "Reset WiFi" appears,
and then reset the WiFi connection referring to the relevant
steps of the WiFi network configuration in the quick setup
instructions.
Whole house cleaning
Click on the whole house cleaning in the mobile phone
application, the machine will perform the whole house
cleaning.
Room cleaning
Click on the room cleaning in the mobile phone
application, add and set rooms, then select the room
and execute cleaning.
Fixed location cleaning
Select target location in the mobile phone application, the
machine will automatically plan the route and get to the
selected location.
Zoning cleaning
Set up zoning cleaning function in the mobile phone
application, the machine will clean the area designated
on the mobile phone.
Standard mode
The default mode is standard mode. Quiet mode, automatic
mode, powerful mode and mop-only mode are optional on
the mobile client.
button