Sony DVS-7200A Installation Manual page 10

4-2. Combination of Optional boards
4-2. Combination of Optional boards
4-2-1. Function of Optional Boards
1. Input
. The primary inputs, 1 through 12, on the rear panel can be used if installing DI-36 board (BKDS-7103)
into Slot 16. Similarly, inputs 13-24 with DI-36 board installed in Slot 17, and inputs 25-36 with DI-36
board installed in Slot 18.
. The analog composite (NTSC) input can be used if installing ADI-3 board (BKDS-7111) onto ADC-21
board (BKDS-7110).
. The serial digital input can be used if installing DI-34 board (BKDS-7113) onto ADC-21 board
(BKDS-7110).
. The names for the ADI-3 and DI-34 boards printed on the ADC-21 board mean the name of the input
connector for DVS-7200A.
2. Output
. The analog composite output can be used if installing DA-94 board (BKDS-7161) onto the OUT-9
board.
. The serial digital input can be used if installing SD-48 board (BKDS-7163) onto OUT-9 board.
. The names for the DA-94 and SD-48 boards printed on the OUT-9 board mean the name of the output
connector for DVS-7200A.
4-2-2. Relation between Optional Boards and Rear Panel Connectors
Install the applicable optional boards to the specified slots according to the signal to be input and output.
The following table shows the relations between rear panel connectors, signals to be input and output,
boards and slot numbers.
<DVS-7200A Rear Panel>
PRIMARY INPUTS
31 25 19
32 26 20
33 27 21
34 28 22
35 29 23
36 30 24
4-4
AUX BUS
OUTPUTS
1
13 7 7 1
14 8 2 8 2
15 9 3 9 3
10 4 10 4
16
17 11 5 11 5
18 12 6 12 6
13
ME-1 ORK INPUT/
OUTPUTS D1 PRIMALY INPUTS
Y/G Y/G
ME-2
OUTPUTS
B-Y/B B-Y/B
CH 3 CH 1
DSK PGM
OUTPUTS
R-Y/R R-Y/R
PGM
OUTPUTS SYNC SYNC
3 1
Y/G Y/G
4 2
CLEAN PVW
OUTPUT OUTPUT B-Y/B B-Y/B
CH 4 CH 2
EDIT PVW DIRECT
OUTPUT INPUT
R-Y/R R-Y/R
SYNC SYNC
SERIAL REF
GPI TERMINAL TALLY PANEL 1 INPUTS
REMOTE 4 DME 2 DME 1
REF
OUTPUT
MATRIX DME 4 DME 3
PANEL 2 EDITOR B EDITOR A
/REMOTE 3 /REMOTE 2 /REMOTE 1
DVS-7200AE IM