Stopping Charging; Using The Temperature Sensor; Use Jump Start Function (Jump Start Mode); Switching The Display - AEG LT60 Instructions For Use Manual

note:
once the battery is fully charged, the charger will
switch to trickle charge to maintain the charging
status and protect the battery from overcharging�

Stopping charging

Press the (27) button�

Using the temperature sensor

The charger can measure the battery tempera-
ture and adjust the charging phase to the battery
temperature�
1� connect the cable for the temperature sensor (1)
to the charger�
Illustration:
connecting terminal (-)
Illustration: lT60 back panel
2� Plug the cable for the temperature sensor (1)
into the designated connection on the black (-)
terminal connection cable with clamp (2)�
3� Plug the charger plug into a 230V power socket�
4� start the charging process (see „start charging")�

Use jump start function (jump start mode)

The charger's jump start function (13) can be used
to help start vehicles with a weak battery� In very
low temperatures or if the battery voltage is below
8�5 V charge the battery at least 5 minutes before
jump starting�
1� connect the charger as described under "con-
necting the device"�
2� repeatedly press the MoDe (29) button to
select jump start mode 12V (13)�
(27) to switch to Jump start
3� Press the button
mode�
note: The Jump start mode can only be used with a
connected battery�
The display shows the current battery voltage� The
battery will be charged at 5 a until the engine is
started�
note:
The jump starting mode will automatically stop
after approx� 30 seconds to prevent damage to the
device�
Attention!
Do not turn the ignition for more than 5 seconds at
a time�
4� Try starting the vehicle�
note:
Try starting for max� 30 seconds� Wait approx� 3
minutes before trying to start it again to allow the
charger and battery to cool down�
5� Press the button (27) to stop the Jump start
mode

Switching the display

During the charging process you can repeatedly
press the „V / %" button (24) to display the following
parameters:
•
V = charging voltage
•
% = battery charge condition
before charging only the current battery voltage
can be displayed, and after charging only the bat-
tery charge condition�
English 27