Quick Start-Up Keypad Control; Drive Operating Displays - ABB ACS260-04 Series User Manual

enable/disable closed the display will show (
seconds the drive will go into standby mode, display shows
speed reference signal.

Quick Start-up Keypad Control

To allow the ACS260 to be controlled from the keypad in a forward direction only, set
parameter 1103 PRIMARY COMMAND SOURCE MODE =1:

Drive Operating Displays

1. Perform Mechanical and Electrical installation as Section Application Marcos.
2. Connect a control switch between the control terminals 1 and 2 ensuring that the
contact is open (drive disabled).
3. Switch on the supply to the drive, Press and hold the navigate key for > 1 to enter
parameter view mode and set parameter 1103 Primary Command Source Mode =
1.
4. Enable the drive by closing the switch between control terminals 1 & 2. The
display will show
5. Press the key. The display shows (
change it using the
6. Press to increase speed.
7. The drive will run forward, increasing speed until
acceleration is controlled by the setting of parameter 2202 ACCELERATION
RAMP TIME, check this before starting.
8. Press to decrease speed. The drive will decrease speed until
The rate of deceleration is limited by the setting in 2203 DECELERATION RAMP
TIME.
9. Press the key. The drive will decelerate to rest at the rate set in parameter
2203 DECELERATION RAMP TIME.
10. The display will finally show
11. To preset a target speed prior to enable, press the
stopped. The display will show the target speed, use the
as required then press the
12. Pressing the
StoP.
(Navigate).
StoP
at which point the drive is disabled.
key to return the display to
key will start the drive accelerating to the target speed.
H 0.0
) (0.0Hz), if left like this for 60
standbY
H 0.0
) . If the display is not showing Hz,
is released. The rate of
key while the drive is
StoP
Start-up 35
, waiting for a
is released.
& keys to adjust
.