Log Commands; Configuring What You Want The Zyxel Device To Log; Table 68 Sys Log; Table 69 Log Categories And Available Settings - ZyXEL Communications NWA-3160 Series User Manual

Table 67 ICMP Notes (continued)
TYPE CODE
8
0
11
0
1
12
0
13
0
14
0
15
0
16
0

Table 68 Sys log

LOG MESSAGE
Mon dd hr:mm:ss hostname
src="<srcIP:srcPort>"
dst="<dstIP:dstPort>"
msg="<msg>" note="<note>"

15.4 Log Commands

Go to the command interpreter interface (the Command Interpreter appendix explains how to access and
use the commands).

15.4.1 Configuring What You Want the ZyXEL Device to Log

Use the sys logs load command to load the log setting buffer that allows you to configure which logs
the ZyXEL Device is to record.
Use sys logs category followed by a log category and a parameter to decide what to record

Table 69 Log Categories and Available Settings

LOG CATEGORIES
error
mten
0
Use to not record logs for that category,
alerts for that category, and
Use the sys logs save command to store the settings in the ZyXEL Device (you must do this in order
to record logs).
ZyXEL NWA-3160 Series User's Guide
DESCRIPTION
Echo
Echo message
Time Exceeded
Time to live exceeded in transit
Fragment reassembly time exceeded
Parameter Problem
Pointer indicates the error
Timestamp
Timestamp request message
Timestamp Reply
Timestamp reply message
Information Request
Information request message
Information Reply
Information reply message
DESCRIPTION
This message is sent by the "RAS" when this syslog is
generated. The messages and notes are defined in this
appendix's other charts.
AVAILABLE PARAMETERS
0, 1, 2, 3
0, 1
1
to record only logs for that category,
3 to record both logs and alerts for that category.
Chapter 15 Log Screens
2
to record only
179