Setting The Energy Saver Timer - Zenith HYDROTAP 30009 Installation And Operating Instructions Manual

Filtered boiling and chilled drinking water for kitchens and tea rooms
Table of Contents

Advertisement

Mode Plus Button
Mode Minus Button
Zenith Hydro Tap Installation and Operating Instructions - 81467 - February 2005

Setting the Energy Saver Timer

Normal Operation (not available on HT boiling only series)
Set Time
To change time, press either Mode ∧ or Mode ∨ button until Set Time is on
the display screen. Press ∧ Adjust button to increase time or ∨ Adjust button
to decrease time. Time increases or decreases in increments of one minute.
Hold the Adjust buttons down for rapid increases or decreases.
Set Day
Press either Mode ∧ or Mode ∨ button until Set Day is displayed.
Press ∧ Adjust or ∨ Adjust to select day.
Filter Life ( factory set at 6000 litres )
Press either Mode ∧ or Mode ∨ button until Filter Life is displayed.
Press ∧ Adjust button to increase Filter Life or ∨ Adjust button to decrease
Filter Life.
Filter Life increases in 1000 Ltr increments to a maximum of 10000 Ltrs.
Reset Litres Filtered
This function is to reset the Filter Change display after a filter has reached the
end of its life (refer to "Replace Filter Instructions" section of this document).
Press either Mode ∧ or Mode ∨ button until Litres Filtered is displayed. Press
∧ Adjust once and "Reset Counter" will be displayed, press ∧ Adjust button
once and "Are You Sure" will be displayed.
Press ∧ Adjust once and Litres Filtered will be reset to 0.
Activating Sleep Mode
This mode allows the HydroTap to go into Energy Saving mode. In this mode
the unit will go to "sleep" after a pre-determined period of inactivity. Press either
Mode ∧ or Mode ∨ button until Sleep Mode is displayed. Press ∧ Adjust once
to select 2 Hours or twice to select 4 Hours. When the period of inactivity
passes, the display will show "Sleep Mode". During sleep mode the Red LED on
top of the tap lever will flash slowly.
Activating On / Off Mode
Press either Mode ∧ or Mode ∨ button until "Monday On" is displayed. To set the
time for the unit to turn on press ∧ Adjust button until required time is reached.
To set the time for the unit to turn Off press Mode ∧ button once and Monday Off
will be displayed. Now press ∧ Adjust until required time is reached.
If each individual day is to have an "On / Off" time, these steps need to be
repeated for each day and for each "On / Off" time.
(products with this feature only)
Plus Adjust Button
Minus Adjust Button
Page 11 of 20

Advertisement

Table of Contents
loading

Table of Contents