Crankcase / Crankshaft - Makita Dolmar DCS460 Repair Manual

12 CRANKCASE / CRANKSHAFT

MS
2
3
4
5
The crankcase magnet side and cylinder side
are held together with six screws 1.
Two pins 2 ensure proper fitting.
To assemble the ball bearings please note the
following repair instructions
•
Press a ball bearing onto the crankshaft
clutch-side by using an assembling bush.
Press only on the internal ring of the
bearing.
Note: Put a wedge between the
crankwebs.
•
Heat the crankcase clutch-side up to 150 -
0
160 Celsius (302-320
evenly coat the external ring of the ball
bearing with Loctite 601 and slide it
together with the crankshaft in the warm
crankcase without any effort.
KS
Note: Degrease both ball bearings before
coating the external ring with Loctite 601.
•
Heat the crankcase magneto-side up to
0
150 -160 Celsius (302-320
evenly coat the external ring of the ball
bearing with Loctite 601 and slide it in the
warm crankcase without any effort.
•
Assemble the crankcase halves. Put a
wedge between the crankwebs
Always use a new gasket. After bolting the
1
crankcase sides together, cut off the flash 3.
Makita is providing crankcases as a spare part
where the ball bearings are already glued into
the crankcase
0
Fahrenheit),
0
Fahrenheit),
27