View Log (Cmd 85) - Bosch D623 User Manual

View Log (Cmd 85)

I can perform this command.
I cannot perform this command.
Use this command to display system events, such as alarm events, turning the system All On, Part On, and Part 2 On, and
turning the system off. Events are displayed in reverse chronological order.
1. Press [CMD] [8] [5]. The command center may prompt you to enter a valid passcode.
2. Enter your passcode if necessary. The command center displays the event and user information and the date
and time of the event.
3. Press [*] to view to the next event.
4. Press [CMD] to exit this function and return to the normal display.
Figure 1 shows a sample log event entry as displayed on the Text command center:
The first line of the log shows the event description. The second line of the log display alternates between the
time and date of the event and the area, point (device), user and communication information for the event.
The command center displays time in a 24-hour format and the date in a MM/DD/YY format.
The log displays the following characters to communicate certain information:
© 2003 Bosch Security Systems
1
Sensor Mon Rstl
A1 Pt3 SL
4
2
3
Display Description
A# Area number
Pt## Point number
Dv### Device number
Ln## Phone line number
Mn# Minutes until Auto Arm Sked
Cd## User Code number
Op## Output number
Ks## Keyswitch number
U## User number
## Communication status for Routing Destinations 1 and 2
- (dash) Destination disabled
A Aborted
D Deleted from pending buffer by panel reset
F Faulted
L Local
P Pending
S Sent
D623/D625 User Guide
1
Sensor Mon Rstl
08:29 06/13/01
5
Page 41
Security System
User Guide
6
1 - Event
2 - Event specific information
3 - Destination 1
4 - Destination 2
5 - Time of event
6 - Date of event
46841D