Table of Contents
Advertisement
Security System
User Guide
Change Others' Passcode Authority Levels (Cmd 56)
I can perform this command.
I cannot perform this command.
Use this command to change passcode authority levels for each user in the system. This command requires the appropriate
authority level to change passcodes. You cannot change your own passcode authority level. Only use this feature under the
direction of your security company. The following is filled in by your security company.
• Authority Level 1 includes these commands:
_________________________________________________________________________________________
• Authority Level 2 includes these commands:
__________________________________________________________________________________________
• Authority Level 3 includes these commands:
__________________________________________________________________________________________
• Authority Level 4 includes these commands:
__________________________________________________________________________________________
1.
Make sure the system is turned off (On indicator is off).
2.
Press [CMD] [5] [6]. The command center may prompt you to enter a valid passcode.
3.
Enter your passcode if necessary. The command center scrolls the following:
4.
Press [2] to change passcode authority levels. The command center display scrolls:
5.
Enter the passcode number (1 to 32) that you want to change the authority level for, followed by [*] (for
example, press [3] [*] to change the authority level for Passcode 3). The command center display scrolls
the following:
If the user does not exist in the system, the command center emits an error tone.
IMPORTANT
6.
Enter the new authority level (1 to 4) for the passcode that you want to change. The authority levels are
determined by the installing company.
7.
Press [CMD] to exit this feature. Press [CMD] again to return to the normal display.
46841D
Push 1 to change
codes.
Push 2 to change
authority level.
To change level
for code 3,
Press 3*.
To change level
for code 4,
Press 4*.
Push Cmd to exit
Code 3 level 2
Enter new level.
Level choices
are 1 to 4.
Push Cmd to exit
D623/D625 User Guide
Page 22
© 2003 Bosch Security Systems
Advertisement
Table of Contents
