Table of Contents
Advertisement
PoE. See:
l
Assigning a PoE Power Budget on
l
Budgeting PoE Power on page 32
l
Logs. See
l
Viewing PoE Port Status
The PoE panel displays a status for each port in the Status column. Statuses include the following:
Green
Powered
High
powered
Gray
Disconnected There is no device connected to the port.
Unpowered
Yellow Overloaded
Low current
Red
Error
Tip: If a camera is disconnected then reconnected to the device, you may need to refresh this page
to view the latest status and budget values.
Viewing PoE Port Status
Providing Device Logs for Support on page 27
A PoE device is connected to the port and is operating normally.
PoE+ is turned on.
The PoE port power is switched off from the PoE page in the ACC ES Admin
Web UI
A PoE device is connected to the port but is not receiving power. This status
typically occurs when one port is overcurrent, or the device is requesting more
power than budgeted, etc.
The device is getting low current from the port.
The device is in an error state.
page 26.
20
Advertisement
Table of Contents
