Language - Yamaha RX-V3800 Owner's Manual

Audio Info. (Audio information)
Format Signal format. When this unit cannot detect a
digital signal, it automatically switches to
analog input.
Sampling The number of samples per second taken from
a continuous signal to make a discrete signal.
Channel The number of source channels in the input
signal (front/surround/LFE). For example, a
multi-channel soundtrack with 3 front
channels, 2 surround channels and LFE, is
displayed as "3/2/0.1".
Bitrate The number of bits passing a given point per
second.
Dialogue The dialogue normalization level preset to the
current input bitstream signal (see page 138).
Flag1/Flag2 Flag data encoded in the bitstream, or PCM
signals that cue this unit to automatically
switch decoders ("Surround EX", etc.).
Notes
• "–––" appears when this unit cannot display the corresponding
information.
• Some high definition audio bitstream contents may not include
the discrete surround back left and right channel signals but are
encoded at the bitrate of 192 kHz.
• Even if you make settings to output bitstreams directly, some
players convert the Dolby TrueHD or Dolby Digital Plus
bitstreams to the Dolby Digital bitstreams, while converting the
DTS-HD Master Audio or DTS-HD High Resolution Audio
bitstreams to the DTS bitstreams.
Video Info. (Video information)
HDMI Signal Type of the source video signals and
the video signals output at the HDMI
OUT jack of this unit.
HDMI Resolution Resolution of the input signal (analog
or HDMI) and the output signal
(HDMI).
Analog Resolution
Resolution of the source video signals
and the analog video signals output at
the COMPONENT MONITOR OUT
jacks of this unit.
HDMI Error Error message for HDMI sources or
connected HDMI devices. See
(HDMI Message)
page 131 for details.
Graphical user interface (GUI) screen

Language

Use this feature to select the language of the menu items
and messages that appears in the GUI (graphical user
interface) screen of this unit.
Choices: English (English),
Français (French), Deutsch (German),
Español (Spanish), Русский (Russian)
y
You can also select the GUI language using the "GUI
LANGUAGE" parameter in "ADVANCED SETUP" in the front
panel display (see page 126).
Set the operation mode selector to D AMP
1
and then press G SET MENU on the remote
control.
The top display appears.
2
Press 4 n repeatedly to select "Language"
and then press 4 h.
System Memory
Signal Info.
Language
3
Press 4 k / n repeatedly to select the
language of your choice.
Press 4 ENTER to confirm your selection.
4
(Japanese),
English
Français
99
En