Page 1: Table Of Contents
5.2 Adaptation to different types of gas 5.3 Positioning 5.4 Electrical connection 5.5 Instructions for the installer We advise you to read this manual carefully, as it contains all the instructions for maintaining the appliance’s aesthetic and functional qualities. For further information on the product: www.smeg.com...
Page 2: Instructions
Instructions 1 Instructions • Keep children under the age of 8 away from the appliance when it 1.1 General safety instructions is in use. • Cleaning and maintenance must Risk of personal injury not be carried out by • During use the appliance and its unsupervised children.
Page 3 Instructions • While cooking do not place metal • DO NOT USE AEROSOLS IN objects, such as cutlery or dishes THE VICINITY OF THIS on the hob surface as they may APPLIANCE WHILST IT IS IN overheat. USE. • Do not insert pointed metal objects •...
Page 4 Instructions Risk of damaging the appliance • Do not spray any spray products near the oven. • Do not use abrasive or corrosive • Do not use plastic cookware or detergents (e.g. scouring containers for cooking. powders, stain removers and metallic sponges) on glass parts.
Page 5 Instructions • Take care not to spill acid Installation substances such as lemon juice or • THIS APPLIANCE MUST NOT BE vinegar on the hob. INSTALLED IN A BOAT OR • Do not put empty pans or frying CARAVAN. pans on switched on cooking •...
Page 6: Manufacturer Liability
Instructions • At the end of the installation, check 1.2 Manufacturer liability for any leaks with a soapy The manufacturer declines all liability solution, never with a flame. for damage to persons or property • Have the electrical connection caused by: performed by authorised •...
Page 7: Disposal
Instructions 1.4 Disposal Our appliances are packaged in non-polluting and recyclable This appliance must be materials. disposed of separately from • Deliver the packing materials to other waste (Directives the appropriate recycling centre. 2002/95/EC, 2002/96/EC, 2003/108/EC). The appliance Plastic packaging does not contain substances in Danger of suffocation quantities sufficient to be considered...
Page 8: How To Read The User Manual
Instructions 1.7 How to read the user manual This user manual uses the following reading conventions: Instructions General information on this user manual, on safety and final disposal. Description Description of the appliance and its accessories. Information on the use of the appliance and its accessories.
Page 9: Description
Description 2 Description 2.1 General Description 1 Cooking hob 5 Door 2 Control panel 6 Fan 3 Light bulb 7 Storage compartment 4 Seal Rack/tray support frame shelf...
Page 10: Cooking Hob
Description 2.2 Cooking hob AUX = Auxiliary burner SR = Semi-rapid burner UR = Ultra-rapid burner 2.3 Control panel 1 Timer knob 3 Temperature knob This knob allows you to select the cooking Allows you to set manual cooking or a timer temperature.
Page 11: Other Parts
Description 4 Indicator light Cooling fan The indicator light comes on to indicate that The fan cools the oven and comes into the oven is heating up. It turns off as soon as operation during cooking. it reaches the set temperature. The fan causes a steady outflow of air that It flashes regularly to indicate that the exits from the rear of the appliance and...
Page 12: Available Accessories
Description 2.5 Available accessories Tray rack Not all accessories are available on some models. Rack To be placed over the top of the oven tray; for cooking foods which may drip. Ring reducer Used for supporting containers with food during cooking. Useful when using small cookware.
Page 13: Use
3 Use Improper use Risk of damage to surfaces 3.1 Instructions High temperature inside the oven • Do not cover the bottom of the oven during use cavity with aluminium or tin foil sheets. Danger of burns • If you wish to use greaseproof paper, place it so that it will not interfere with the •...
Page 14: First Use
3.3 Using the accessories High temperature inside the storage compartment during use Ring reducers Danger of fire or explosion The ring reducers have to be placed on the hob grids. Make sure they are placed • Do not spray any spray products near properly.
Page 15: Using The Hob
Racks and trays 3.4 Using the hob All the appliance’s control and monitoring Racks and trays have to be inserted into the devices are located together on the front side guides until they come to a complete panel. The burner controlled by each knob stop.
Page 16: Using The Oven
3.5 Using the oven Correct positioning of the flame- spreader crowns and burner caps Switching on the oven Before lighting the hob burners, make sure To switch on the oven: that the flame-spreader crowns are 1. Set the cooking duration using the minute correctly positioned in their seats with their minder knob.
Page 17: Using The Storage Compartment
• It is not possible to shorten cooking times Fan with grill by increasing the temperature (the food The air produced by the fan softens could be overcooked on the outside and the strong heatwave generated by undercooked on the inside). the grill, grilling perfectly even very thick foods.
Page 18 Advice for cooking desserts/pastries and Advice for defrosting and proving biscuits • Place frozen foods without their • Use dark metal moulds: They help to packaging in a lidless container on the absorb the heat better. first shelf of the oven. •...
Page 19 Cooking information table Static oven Fan-assisted oven Runner Weight position Food Temperature Time Temperature Time from the (kg) (°C) (minutes) (°C) (minutes) bottom Lasagna 230 - 240 50 - 60 230 - 240 45 - 50 Cannelloni 220 - 230 25 - 30 220 - 230 25 - 30...
Page 20: Cleaning And Maintenance
Cleaning and maintenance 4 Cleaning and maintenance Cleaning the hob 1. Pour some non-abrasive detergent on a 4.1 Instructions damp cloth and wipe the surface. 2. Rinse thoroughly. Improper use Risk of damage to surfaces 3. Dry with a soft cloth or a microfibre cloth. Cleaning the hob grids, flame-spreader •...
Page 21: Removing The Door
Cleaning and maintenance Cleaning the igniters and thermocouples 4.3 Removing the door For easier cleaning, the door can be • If necessary, clean the igniters and removed and placed on a tea towel. thermocouples with a damp cloth. To remove the door proceed as follows: •...
Page 22: Cleaning The Door Glazing
Cleaning and maintenance 4.5 Removing the internal glass 3. To reassemble the door, put the hinges in the relevant slots in the oven, making sure panes that grooved sections A are resting The door glazing should always be kept completely in the slots. Lower the oven thoroughly clean.
Page 23 Cleaning and maintenance 3. Clean the external glass pane and the Removing racks/trays support frames internal pane which you have removed Removing the rack/tray support frames previously. Use absorbent kitchen roll. In enables the sides to be cleaned more case of stubborn dirt, wash with a damp easily.
Page 24: Extraordinary Maintenance
Cleaning and maintenance 4.7 Extraordinary maintenance Replacing the internal light bulb Installing and removing the seal Live parts Danger of electrocution To remove the seal: • Unhook the clips in the 4 corners then • Unplug the appliance from the mains. pull the seal outwards.
Page 25 Cleaning and maintenance 4. Slide out and remove the light bulb. Do not touch the halogen light bulb directly with your fingers, use an insulating material. 5. Fit the new light bulb. 6. Refit the cover. Ensure the moulded part of the glass (A) is facing the door.
Page 26: Installation
Installation 5 Installation Connection with a rubber hose Verify that all following conditions are met: 5.1 Gas connection • the hose is fixed to the hose connection with safety clamps; Gas leak • no part of the hose is in contact with hot Danger of explosion walls (max.
Page 27 Installation After tightening the hose connector(s), push Carefully screw the connector 3 to the gas the gas hose 6 onto the hose connector connector 1 of the appliance, placing the and secure it with the clamp 5, which must seal 2 between them. be compliant with applicable regulations.
Page 28 Installation Connection with a steel hose with conical Room ventilation fitting The appliance should be installed in rooms Make the connection to the gas mains that have a permanent air supply in using a continuous wall steel hose whose accordance with the standards in force. The specifications comply with the applicable room where the appliance is installed must standard.
Page 29: Adaptation To Different Types Of Gas
Installation When the job is complete, the installer must 5.2 Adaptation to different types of issue a certificate of conformity. In case of operation with other types of gas, the burner nozzles must be changed and the minimum flame adjusted on the gas cocks.
Page 30 Installation Replacing the oven burner nozzle 6. Take out the burner pulling it outwards until the nozzle is accessible. 1. Open the door. 7. Replace the nozzle using a 7 socket 2. Remove all accessories from inside the wrench. oven. 3.
Page 31 Installation Adjusting the oven burner minimum Adjusting the minimum setting for LPG setting Tighten the screw located at the side of the The oven thermostat is equipped with a cock rod clockwise all the way. screw for regulating the minimum. When Following adjustment to a gas changing the type of gas supply, the other than the one originally set in...
Page 32 Installation Gas types and Countries Gas types IT GB-IE FR-BE DE RU DK Natural Gas G20 20 mbar • • • • • • • • • LPG G30/31 G30/31 28/37 mbar • • • • • • G30/31 30/37 mbar City Gas G110 G110 8 mbar...
Page 33 Installation Burner and nozzle specifications tables Natural gas G20 - 20 mbar Oven Rated heating capacity (kW) 1.05 Nozzle diameter (1/100 mm) Pre-chamber (printed on nozzle) (H3) Reduced flow rate (W) 1600 LPG G30/31 - 30/37 mbar Oven Rated heating capacity (kW) 1.05 Nozzle diametre (1/100 mm) Pre-chamber (printed on nozzle)
Page 34: Positioning
Installation 5.3 Positioning Dimensions Heavy appliance Crushing hazard • Position the appliance into the cabinet cut-out with the help of a second person. Pressure on the open door Risk of damage to the appliance • Never use the oven door to lever the 600 mm appliance into place when fitting.
Page 35 Installation Depending on the type of installation, this Position of gas and electrical connections appliance belongs to classes: A - Class 1 53 mm (Free-standing appliance) 623 mm 121 mm 27 mm E Gas connection F Electrical connection General information This appliance may be installed next to walls, one of which must be higher than the worktop, at a minimum distance of 100 mm...
Page 36 Installation Positioning and levelling Heavy appliance Risk of damage to the appliance • Insert the front feet first and then the rear ones. • After making the gas and electrical connections, screw on the four feet supplied with the appliance. C - Class 2 subclass 1 (Built-in appliance) The appliance must be installed by...
Page 37 Installation 3. Assemble the fastening bracket. Fastening to the wall The anti-tip devices must be installed in order to prevent the appliance from tipping over. 1. Screw the wall fastening plate to the rear of the appliance. 4. Align the base of the hook on the fastening bracket with the base of the slot on the wall fastening plate.
Page 38 Installation 5. Align the base of the fastening bracket 7. Move the bracket onto the wall and with the ground and tighten the screws to mark the position of the holes to be fix the measurements. drilled in the wall. 6.
Page 39: Electrical Connection
Installation 5.4 Electrical connection Assembling the upstand The upstand provided is an Power voltage integral part of the product; it must Danger of electrocution be fastened to the appliance prior to installation. • Have the electrical connection performed by authorised technicians. The upstand must always be positioned and •...
Page 40 Installation The appliance can work in the following Testing modes: At the end of installation, carry out a brief • 220 - 240 V 1N~ inspection test. If the appliance fails to operate, after checking that you have followed the instructions correctly, unplug the appliance and contact Technical Support.
Page 41: Instructions For The Installer
Installation 5.5 Instructions for the installer • The plug must be accessible after installation. Do not bend or trap the power cable. • The appliance must be installed according to the installation diagrams. • Do not try to unscrew or force the threaded elbow of the fitting.

Smeg B60GVXI9 Manual

1 Instructions

2 Description

3 Use

4 Cleaning and Maintenance

5 Installation

Quick Links

Related Manuals for Smeg B60GVXI9

Summary of Contents for Smeg B60GVXI9

Table of Contents