Scanned Original Setup; Contrast Setup; Brightness Setup; Paper Type Setup - Xerox Phaser 3100MFP/S User Manual

Scanned original setup

If you want, you can change the origin of the scanner.
By entering new values for X and Y in mm (X < 209 and
Y < 280), you move the scanned area as shown on the
diagram below.
843 - ADVANCED FCT/COPY/ORIGIN
1 Press , enter 843 using the keypad.
2 Select the X and Y coordinates with the buttons
or .
3 Setup the desired coordinates with the numerical
keypad or the buttons
4 Confirm your choice by pressing the OK button.
5 Exit this menu by pressing the

Contrast setup

The CONTRAST parameter allows you to choose your
output's contrast.
844 - ADVANCED FCT/COPY/CONTRAST
1 Press , enter 844 using the keypad.
2 Setup the desired level of contrast with the buttons
and .
3 Confirm your choice by pressing the OK button.
4 Exit this menu by pressing the

Brightness setup

The BRIGHTNESS parameter allows you to lighten or
darken your output.
845 - ADVANCED FCT/COPY/BRIGHTNESS
1 Press , enter 845 using the keypad.
2 Setup the desired brightness with the buttons
and .
3 Confirm your choice by pressing the OK button.
4 Exit this menu by pressing the

Paper type setup

851 - ADVANCED FCT/SCAN. & PRINT/PAPER
1 Press , enter 851 using the keypad.
2 Select NORMAL or THICK with the buttons
and .
3 Confirm your choice by pressing the OK button.
4 Exit this menu by pressing the
and .
button.
button.
button.
TYPE
button.
- 23 -

Paper tray selection

The Automatic selection can have two meanings
depending on the paper size defined for the paper trays.
The following table describes the different cases.
Default tray
AUTOMATIC
Same paper
size in the
trays
Manual
AUTOMATIC The main tray is used.
Different
paper size in
Manual
the trays
852 - ADVANCED FCT/SCAN. & PRINT/TRAY
1 Press , enter 852 using the keypad.
2 Select the default paper tray to use, AUTOMATIC
or MANUAL, with the buttons
3 Confirm by pressing the OK button.
4 Exit this menu by pressing the

Margin Shift using the Document Glass

If you want to, you can offset the lateral margins of the
document to the left or right during the scanning from the
document glass.
854 - ADVANCED FCT/SCAN. & PRINT/
1 Press , enter 854 using the keypad.
2 Setup the left / right margins offsets (by 0.5 mm
steps) with the buttons
3 Confirm by pressing the OK button.
4 Exit this menu by pressing the

Left and right printing margin shift

If you want to, you can offset the lateral margins of the
document to the left or right during printing.
855 - ADVANCED FCT/SCAN. & PRINT/
1 Press , enter 855 using the keypad.
2 Setup the left / right margins offsets (by 0.5 mm
steps) with the buttons
3 Confirm by pressing the OK button.
4 Exit this menu by pressing the
Phaser 3100MFP/S
Tray used for copy
Selection between the
main tray and the
manual tray.
The manual tray is
used.
The manual tray is
used.
PAPER
and .
button.
FLATBED MARG
and .
button.
PRINTER MARG
and .
button.