Installation; Mounting Applications - Bosch 4405 Operating/Safety Instructions Manual

To avoid injury always observe
! WARNING
the following:
G
Unplug electric cord. Before transporting the
saw, rotate head assembly to 45° right miter,
lock into detent, pull the head assembly com-
pletely forward toward you, tighten the slide
rail lock knob and lock the head assembly in
the lowered position.
G
To avoid back injury, hold the tool close to your
body when lifting. Bend your knees so you can
lift with your legs, not your back. Lift by using
the cast-in carry handles at each side of the bot-
tom of the base or the carry handle.
G
Never carry the tool by the slide rails, this
may cause blade misalignment.
Workbench
Mount the saw using either the four bolt holes (7/16") or
the four screw holes (1/4") to the workbench (Figure
16). Check for clearance to the left and right of the saw.
Bolt Holes
Screw Holes
Figure 16. Workbench Mounting

Installation

Mounting Applications

Screw Holes
Bolt Holes
G
Never carry the miter saw by the power cord or
the operational handle. Attempting to lift or
carry the tool by the power cord will damage
the insulation and the wire connections result-
ing in electric shock or fire.
G
Observe the position of the saw. People
standing behind it could be injured by thrown
debris.
G
Place the saw on a firm, level surface where
there is plenty of room for handling and proper-
ly supporting the workpiece.
G
Bolt, screw, nail or clamp the saw to its
support surface.
Be careful not to over drive nail
! CAUTION
or over torque the bolt when
attaching to support surface. This could crack foot
or damage base.
1. Each of the four mounting holes should be bolt-
ed securely using 3/8" bolts, lock washers, and
hex nuts (not included).
2. Locate and mark where the saw is to be mount-
ed.
3. Drill four (4) 3/8" diameter holes through work-
bench.
4. Place the slide compound miter saw on the
workbench aligning holes in base with holes
drilled in workbench. Install bolts, lock wash-
ers and hex nuts.
Supporting surface where saw is to be mounted
should be examined carefully after mounting to
ensure that no movement can occur during use. If
any tipping or walking of the saw is noted, check your
mounting to the workbench or stand, and make nec-
essary adjustments before operating the slide com-
pound miter saw (see Stability Bar Adjustment on
page 18).
17.