Siemens SINUMERIK 840D Description Of Functions page 295

11.03
Fig. 5-3
The vertical softkeys axis +, axis - or direct selection are used to set the desired
axis. The current axis is displayed at the top righthand side of the table.
Safe actual position
Available
values/signals Position deviation NCK/drive
"Safe operating stop" monitoring active
"Safely-reduced speed" monitoring active
Active SG step
Active SG correction factor
Safely-reduced actual speed limit
Setpoint speed limit
Actual speed difference
Maximum speed difference
Active safe software limit switch
Active gear ratio (step)
Active stop
Currently requested external stop
Stop F code value (Alarm 300911)
Pulses enabled
Traversing inhibit due to a stop in other axis
The vertical softkeys "SGE/SGA" and "SPL" can be used to select two
additional screens, which show the situation for the safety-relevant inputs/
outputs and the safe programmable logic.
© Siemens AG 2003 All Rights Reserved
SINUMERIK 840D/SIMODRIVE 611 digital SINUMERIK Safety Integrated (FBSI) - Edition 11.03
Status SI
5 Commissioning
5.5 Diagnostics
5-295