Maintenance; Replacing Smoke And Heat Detector Batteries; Replacing Co Detector Batteries - Bosch RADION Life Safety Installation Manual

28 en | Maintenance
10

Maintenance

10.1

Replacing smoke and heat detector batteries

Warning!
Risk of fire or explosion
!
Use only Panasonic CR123A batteries for replacement. Use of another battery may negatively
impact detector operation, and may present a risk of fire or explosion.
Replace detector batteries when:
–
–
After you replace the battery, press the test button to make sure that the detector is
operating.
Figure 10.1: Battery location in detector
Warning!
Risk of fire or chemical burn
!
The battery may present a fire or chemical burn hazard if mishandled. Do not recharge,
disassemble, heat above 100°C (212°F) or dispose of in a fire.
10.2

Replacing CO detector batteries

To replace the batteries in a CO detector:
1.
2.
3.
4.
5.
6.
7.
2020.06 | 03 | F.01U.361.555
the detector makes an intermittent sound and the yellow LED flashes once every 48
seconds
no alarm sound is made during a test
Refer to the "replace by" date on the label. If the "replace by" date has not passed,
replace the batteries. If the detector has been installed for 10 or more years, replace the
detector.
Remove the detector from the mounting plate.
Remove the battery cover.
Insert the new batteries in the correct orientation as shown on the base.
Replace the battery cover.
Place the detector on the mounting plate, which automatically powers the detector.
Test the detector (after 15 seconds) to make sure that the detector is operating.
Installation manual
RADION Life Safety
Bosch Security Systems, B.V.