Enrollment; Programming Wireless Points In The Control Panel - Bosch RADION Life Safety Installation Manual

18 en | Enrollment
7

Enrollment

7.1

Programming wireless points in the control panel

Configure the RADION points to establish communication between the RADION system and
the control panel. This can be accomplished by using one of two methods:
–
–
A "point" can be a detection device, or a group of devices connected to your security system.
The first step to enable communication is to verify that the RADION transmitter is
programmed into the control panel. This is achieved by configuring a point source index as
wireless.
RFID programming from a supported keypad is achieved by:
–
–
The preferred method of entering in the RFID number would be to enter it in manually through
the keypad - point source/RFID, or RPS. Doing so gives you greater control and security, while
reducing the risk of incomplete RFID programming.
The workflow listed below is a generic representation of the programming/enablement
process. Refer to the Points Menu Parameters section inside the Keypad Installer Menu
chapter of the compatible Bosch control panel Installation and System Reference Guides, or
Points - Point Assignments in RPS Help File for more information.
Point source/RFID programming
A point's source gives a description as to the physical location of the point for installation and
service personnel:
1.
2.
3.
4.
5.
6.
7.
8.
The control panel is enabled to receive wireless communication information from the RADION
transmitter.
2020.06 | 03 | F.01U.361.555
Using Remote Programming Software (RPS) on a supported laptop computer, or
Compatible keypad devices to enable your points
Through the point source/RFID menu options, or
Enroll point RFID for wireless points - which uses the "Auto-Learn" methodology.
Using either RPS, or a supported keypad, access the Program Menu, and select the
Points menu option.
Select the Source menu.
Select the point source of the device you are programming.
Change the point source to the "wireless."
Save changes.
Select the RFID menu to edit the RFID of each RADION device.
Enter in the unique RFID as it appears on the RFID sticker in the illustration below. ID's
beginning with a zero may not display in the keypad UI, or RPS
Save changes and exit the menu.
Installation manual
RADION Life Safety
Bosch Security Systems, B.V.